Automated Sandblasting and Painting Systems - Bcs Group/Sandblasting Equipment/Painting Equipment/Abrasive Sand/Compressors

Vertıcal Plate Shotblastıng Machıne

Mon, 15 Dec 2025 02:55:03 -0500

Vertically shotblasted plates exit freely, allowing reduced space usage in the facility and lower energy consumption compared to horizontal machines. Additionally, the top turbines can be switched off for shorter plate widths, achieving savings in manufacturing costs and energy.

Compact Hook Type Shot Blastıng Machıne

Mon, 15 Dec 2025 02:52:52 -0500

Standard hook type shotblasting machines cause approximately 4–5 minutes of downtime between two blasting cycles because the operator has to wait for the turbines to stop completely, open the doors, remove the blasted hook, insert the unblasted hook, close the doors, and wait for the turbines to reach 3000 rpm. In contrast, new-generation compact hook type machines eliminate these time losses, achieving 2.5 times higher productivity compared to standard hook type machines.

Hook Type Shotblastıng Machıne

Mon, 15 Dec 2025 02:43:46 -0500

Cleaning and removing foundry sand from cast parts made of cast iron, steel, aluminum, and brass, especially for geometrically demanding pieces.

Preservation Lıne - Complete Shotlastıng And Paıntıng Lıne

Mon, 15 Dec 2025 02:40:28 -0500

By means of a preservation line, steel sheets (widths can vary from 1500mm up to 3000mm) and profiles (max. heigth 500mm) are shotblasted in SA2,5 quality and painted with a temporary corrosion protection paint at an adjustable speed between 1 - 2,5 m/min. A preservation line consist of : loading and unloading cross conveyors for efficient loading / unloading , individually adapted roller conveyors, a pre-heater for wet or even ice-covered workpieces from outside storage, A roller conveyor shotblasting machine including a dustcollecting and filtering unit, a painting booth with upper and lower painting robots including waterfall type filtering unit, a slat conveyor to protect wet paint and a paint dryer unit to allow the handling of the workpieces immediately at the exit roller conveyor. To minimize energy costs, the paint dryer unit uses waste heat energy from the pre-heater.

Wire Descalıng Machıne

Mon, 15 Dec 2025 02:37:54 -0500

For fastest and most efficient wire descaling, 3 turbines are located around the wire with 1200 Special wear resistant and replacable abrasive concentration plates are placed in front of each turbine to achieve higher efficiency. Usually wire descaling shot blasting machines are integrated in a complete line, before wiredrawing beds. Number of turbines and the applied powers are defined according to customer’s wiredrawing beds’ speed.

Pressure Shotblastıng Machıne

Mon, 15 Dec 2025 02:31:55 -0500

For cleaning, deburring and surface finishing of a variety of small parts , manually pressured blasting is the best solution. All types of non-hygroscopic media from very abrasive materials (e.g. aluminium oxide or silicon carbide) to plastic media and corn cob can be used.